We are excited to announce the release of Honda S2000 rear arch repair panels for the repair of rusty wheel arches. These will be available internationally.
In most European countries where salt is used in winter on the roads, the S2000 rear arches suffer. Most models are now well over 10 years old and once the rust becomes visible on the outside panel it is usually a lot worse than expected. For some reason they seem to rust from the inside out. Replacing the whole rear quarter panel is quite an intrusive and expensive job. So we have worked with a specialist company in West Yorkshire to create a large repair panel, which can be used to cut out all your arch rust and replace with as much of the supplied panel as necessary. This is not the whole quarter panel, but the outer skin from body line down to the sill stretching from the door jam to the rear light cluster.
If the extent of your rust is limited, you can now order the smaller repair panels shown below.
Please note however, that from our experience of seeing the first 3 Honda S2000’s being repaired, that the inner arches and lower extension panels a very often rotten and extensive repairs will be needed. To avoid this, it is advisable that the Honda OEM inner arch repair panels should also be purchased from Ex-Pressed Steel Panels at the same time of ordering. These panels will shortly be carried in stock having been purchased direct from Honda. This will allow you or order them all together and reduce lead times. This will stop your body shop from having long down times waiting for the extra needed panels to be delivered.
Additional Honda panels you will require to restore rear quarter rust
|L Rear Arch Inside Panel||64701-S2A-300ZZ|
|R Rear Arch Inside Panel||64301-S2A-300ZZ|
|L Rear Inner Wheel arch extension||64721-S2A-J00ZZ|
|R Rear Inner Wheel arch extension||64321-S2A-J00ZZ|